SHERWIN-WILLIAMS CO, KRYLON/SPRAYON INDUSTRIAL PRODUCTS -- KRYLON HIGH HEAT RESISTANT PAINTS, 1505 WHITE  -- -
<pre>=====================  Product Identification  =====================

Product ID:KRYLON HIGH HEAT RESISTANT PAINTS, 1505 WHITE
MSDS Date:08/17/1998
FSC:NIIN:Submitter:N EN
Status Code:A
=== Responsible Party ===
Company Name:SHERWIN-WILLIAMS CO, KRYLON/SPRAYON INDUSTRIAL PRODUCTS
Address:31500 SOLON ROAD
City:SOLON
State:OH
ZIP:44139
Country:US
Info Phone Num:800-777-2956
Emergency Phone Num:216-566-2956
Resp. Party Other MSDS Num.:HHR/KRI
CAGE:09800
=== Contractor Identification ===
Company Name:BORDEN CHEMICAL CO
Address:180 E BROAD ST
Box:City:COLUMBUS
State:OH
ZIP:43215-3705
Country:US
Phone:614-225-6124
CAGE:86142
Company Name:BORDEN INC
Address:180 E BROAD ST
Box:208
City:COLUMBUS
State:OH
ZIP:43215-3705
Country:US
Phone:614-225-6124
CAGE:07982
Company Name:KRYLON PRODUCTS
Address:31500 SOLON ROAD
Box:City:SOLON
State:OH
ZIP:44139
Country:US
Phone:800-832-2541/216-566-2917
CAGE:87187
Company Name:KRYLON PRODUCTS
Address:180 EAST BROAD ST
Box:City:COLUMBUS
State:OH
ZIP:43215
Country:US
Phone:614-431-6600;800-848-9400
CAGE:IO479
Company Name:SHERWIN-WILLIAMS CO THE
Address:101 PROSPECT AVE NW
Box:City:CLEVELAND
State:OH
ZIP:44115-1042
Country:US
Phone:800-251-2486/216-566-2242
CAGE:54636
Company Name:SHERWIN-WILLIAMS DIVERSIFIED BRANDS, INC.
Address:26300 FARGO AVENUE
Box:City:BEDFORD HEIGHTS
State:OH
ZIP:44146
Country:US
Phone:216-292-7400 OR 216-595-8634
CAGE:09800

=============  Composition/Information on Ingredients  =============

Ingred Name:PROPANE. (VAPOR PRESSURE 760.0 MM HG)
CAS:74-98-6
RTECS #:TX2275000
= Wt:18.
OSHA PEL:1000 PPM

Ingred Name:XYLENE. (VAPOR PRESSURE 5.9 MM HG)
CAS:1330-20-7
RTECS #:ZE2100000
= Wt:2.
OSHA PEL:100 PPM
OSHA STEL:150 PPM
ACGIH TLV:100 PPM
ACGIH STEL:150 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:ACETONE. (VAPOR PRESSURE 180.0 MM HG)
CAS:67-64-1
RTECS #:AL3150000
= Wt:34.
OSHA PEL:750 PPM
OSHA STEL:1000 PPM
ACGIH TLV:750 PPM
ACGIH STEL:1000 PPM
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:TOLUENE. (VAPOR PRESSURE 22.0 MM HG)
CAS:108-88-3
RTECS #:XS5250000
= Wt:28.
OSHA PEL:100 PPM (SKIN)
OSHA STEL:150 PPM (SKIN)
ACGIH TLV:50 PPM (SKIN)
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS

Ingred Name:METHANOL. (VAPOR PRESSURE 92.0 MM HG)
CAS:67-56-1
RTECS #:PC1400000
= Wt:3.
OSHA PEL:200 PPM (SKIN)
OSHA STEL:250 PPM (SKIN)
ACGIH TLV:200 PPM (SKIN)
ACGIH STEL:250 PPM (SKIN)
EPA Rpt Qty:5000 LBS
DOT Rpt Qty:5000 LBS

Ingred Name:TITANIUM DIOXIDE
CAS:13463-67-7
RTECS #:XR2275000
= Wt:7.6
OSHA PEL:10 MG/M3 AS DUST
ACGIH TLV:10 MG/M3 AS DUST

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:TO MINIMIZE EXPOSURE, FOLLOW
    RECOMMENDATIONS FOR PROPER USE, VENTILATION, AND PERSONAL
    PROTECTIVE EQUIPMENT. ACUTE: EFFECTS OF OVEREXPOSURE: IRRITATION OF
    EYES, SKIN AND RESPIRATORY SYSTEM. MAY CAUSE  NERVOUS SYSTEM
    DEPRESSION. EXTREME OVEREXPOSURE MAY RESULT IN UNCONSCIOUSNESS AND
    POSSIBLY DEATH. SIGNS AND SYMPTOMS OF OVEREXPOSURE: HEADACHE,
    DIZZINESS, NAUSEA, AND LOSS OF COORDINATION ARE INDICATI ONS OF
    EXCESSIVE EXPOSURE TO VAPORS OR SPRAY MISTS. REDNESS AND ITCHING OR
    BURNING SENSATION MAY INDICATE EYE OR EXCESSIVE SKIN EXPOSURE.
    (EFFECTS OF OVEREXPOSURE)
Effects of Overexposure:HEALTH HAZARDS: CHRONIC: PROLONGED OVEREXPOSURE
    TO SOLVENT INGREDIENTS MAY CAUSE ADVERSE EFFECTS TO THE LIVER,
    URINARY, BLOOD-FORMING, CARDIOVASCULAR, AND REPRODUCTIVE SYSTEMS.
    REPORTS HAVE ASSOCIATED  REPEATED AND PROLONGED OVEREXPOSURE
    TOSOLVENTS WITH PERMANENT BRAIN AND NERVOUS SYSTEM DAMAGE. RATS
    EXPOSED TO TITANIUM DIOXIDE DUST AT 250 MG/M3 DEVELOPED LUNG
    CANCER, HOWEVER, SUCH EXPOSURE LEVELS  ARE NOT ATTAINABLE IN THE
    WORKPLACE. TOLUENE APPEARS ON THE NAVY OCCUPATIONAL CHEMICAL
    REPRODUCTIVE HAZARDS LIST. SEEK CONSULTATION FROM APPROPRIATE
    HEALTH PROFESSIONAL CONCERNING SAFE HANDLING AND EX POSURE
    INFORMATION .
Medical Cond Aggravated by Exposure:NONE GENERALLY RECOGNIZED.

=======================  First Aid Measures  =======================

First Aid:INHALATION: IF AFFECTED, REMOVE FROM EXPOSURE. RESTORE
    BREATHING. KEEP WARM AND QUIET. SKIN: WASH AFFECTED AREA THOROUGHLY
    WITH SOAP AND WATER. REMOVE CONTAMINATED CLOTHING AND LAUNDER
    BEFORE REUSE. E YES: FLUSH EYES WITH LARGE AMOUNTS OF WATER FOR AT
    LEAST 15 MINUTES. GET MEDICAL ATTENTION. INGESTION: SEEK MEDICAL
    ATTENTION.

=====================  Fire Fighting Measures  =====================

Flash Point Method:PMCC
Flash Point:<-17.8C, 0.F
Lower Limits:1.0%
Upper Limits:36.5%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:WEAR NIOSH APPROVED SCBA AND FULL PROTECTIVE
    EQUIPMENT . WATER SPRAY MAY BE INEFFECTIVE. IF WATER IS USED, FOG
    NOZZLES ARE PREFERABLE. WATER MAY BE USED TO COOL CLOSED CONTAINERS
    TO PREVENT PRES SURE BUILD-UP AND POSSIBLE AUTOIGNITION OR
    EXPLOSION WHEN EXPOSED TO EXTREME HEAT.
Unusual Fire/Explosion Hazard:EXTREMELY FLAM. FLASH POINT <21F. CLSD
    CONTRS MAY EXPLODE (DUE TO PRESS BUILD-UP) WHEN EXPOS TO EXTREME
    HEAT. ISOLATE FROM HEAT, ELEC EQUIP, SPKS & OPEN FLAME. APPLICATN
    TO HOT SURFS REQUIRES SPECIAL  PRECS. DURING EMER CNDTNS OVEREXP TO
    DECOMP PRODS MAY CAUSE HLTH HAZ. SYMPS MAY NOT BE IMMED APPARENT.
    OBTAIN MED ATTN.

==================  Accidental Release Measures  ==================

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE AND
    REMOVE WITH INERT ABSORBENT.

======================	Handling and Storage  ======================

Handling and Storage Precautions:USE ONLY W/ADEQ VENT. AVOID BRTHG VAP
    & SPRAY MIST. AVOID CONT W/SKIN & EYES. THESE COATINGS MAY CONTAIN
    MATLS CLASSIFIED AS NUISANCE PARTICULATES (LISTED AS DUST IN INGS
    SECTION) WHICH MAY BE PRESENT  AT HAZ LEVELS ONLY DURING
    SANDING/ABRADING OF DRIED FILM. NFPA CODE 30B - LEVEL 3 AEROSOLS.
Other Precautions:CONTENTS ARE EXTREMELY FLAM. KEEP AWAY FROM HEAT,
    SPKS, & OPEN FLAME. VAPS WILL ACCUM READILY & MAY IGNITE EXPLO.
    DURING USE & UNTIL ALL VAPS ARE GONE: KEEP AREA VENTILATED; DO NOT
    SMOKE; EXTING ALL F LAMES, PILOT LIGHTS, & HEATERS; TURN OFF
    STOVES, ELEC TOOLS & APPLIANCES, & ANY OTHER SOURCES OF IGN IT.
    (SUP DAT)

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:IF PERSONAL EXPOSURE CANNOT BE CONTROLLED BELOW
    APPLICABLE LIMITS BY VENTILATION, WEAR A PROPERLY FITTED ORGANIC
    VAPOR/PARTICULATE RESPIRATOR APPROVED BY NIOSH  FOR PROTECTION.
    WHEN SANDING OR ABRADIN G THE DRIED FILM, WEAR A DUST/MIST
    RESPIRATOR APPROVED BY NIOSH FOR PROTECTION AGAINST NON-VOLATILES
    MATERIALS IN INGREDIENTS SECTION.
Ventilation:LOC EXHAUST PREFERABLE. GEN EXHAUST ACCEPTABLE IF EXPOS IS
    MAINTAINED BELOW APPLICABLE EXPOSURE LIMITS. REFER TO OSHA
    STANDARDS 1910.94, 1910.107, 1910.108.
Protective Gloves:FOR LONG OR REPEATED CONTACT, WEAR CHEMICAL RESISTANT
    GLOVES.
Eye Protection:ANSI APPROVED CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EMERGENCY EYEWASH AND DELUGE
    SHOWER .
Work Hygienic Practices:WASH HANDS AFTER USING.
Supplemental Safety and Health
OTHER PREC: CONSULT NFPA CODE. USE APPRVD BONDING & GROUNDING PROC.
    CONTENTS UNDER PRESS. DO NOT PUNCTURE, INCIN/EXPOSE TO TEMP >120F.
    HEAT FROM SUNLIGHT, RADIATORS, STOVES, HOT WATER, & OTHER HEAT SO
    URCES COULD CAUSE CONTR TO BURST. DO NOT TAKE INTERNALLY. KEEP OUT
    OF REACH OF CHILDREN. (OTHER INFO)

==================  Physical/Chemical Properties  ==================

Boiling Pt:<-17.8C, 0.F
B.P. Text:<0F - 395F
Vapor Pres:SEE INGREDIENTS
Vapor Density:HVR/AIR
Evaporation Rate &amp; Reference:FASTER THAN ETHER

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Hazardous Decomposition Products:BY FIRE: CARBON DIOXIDE, CARBON
    MONOXIDE.

====================  Disposal Considerations  ====================

Waste Disposal Methods:WASTE FROM THIS PRODUCT MAY BE HAZARDOUS AS
    DEFINED UNDER RCRA (40 CFR 261). WASTE MUST BE TESTED FOR
    IGNITABILITY TO DETERMINE THE APPLICABLE EPA HAZARDOUS WASTE
    NUMBERS. DO NOT INCINERATE. DEPRESSUR IZE CONTAINER. DISPOSE OF IN
    ACCORDANCE WITH FEDERAL, STATE AND LOCAL REGULATIONS REGARDING
    POLLUTIO N.

=====================  Regulatory Information  =====================

SARA Title III Information:TOLUENE, XYLENE AND METHANOL ARE SUBJECT TO
    THE REPORTING REQUIREMENTS OF THE SUPERFUND AMENDMENTS AND
    REAUTHORIZATION ACT (SARA) SECTION 323, 40 CFR 372.65 C.
Federal Regulatory Information:ALL CHEMICALS IN THIS PRODUCT ARE
    LISTED, OR ARE EXEMPT FROM LISTING, ON THE TSCA INVENTORY.
State Regulatory Information:WARNING: THIS PRODUCT CONTAINS A
    CHEMICAL/S KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND
    BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.

=======================  Other Information  =======================

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.